Material
The Custom Fiberglass Products tank shall be constructed of glass reinforced solid laminated plastic, the ultimate insurance against possible leaks. The durable material requires no maintenance, is lighter in weight than steel or aluminum This material used is high-impact resistant wax free polyester resin.

Shell
Shell is one piece seamless female vertical wall molded with all exterior longitudinal corners having 1" radius depending on tank gallonage. All 1/2" or more floor with 3/8" or more bulkheads and sides reinforced and tested for integrity and ZERO leakage. Outside flange design for fully removable lid design. Exterior is white in color.

An outside flange or optional recessed flange design is used to eliminate water contact with the stainless steel bolts. The recessed flange makes the outside of the tank even with the outside tank walls and allows clean placement within the body panels. These flange sections add extensive reinforcement rigidity and strength to the structure.

Baffles
Baffle partitions shall be constructed of reinforced 5/16" or more POL-E material. Main baffle partition shall be a one piece design and extend from front to rear of the tank. All baffle partitions are reinforced and integrated to side walls to provide greatest strength and allow maximum air and water flow, minimum surging, and to comply with NFPA 1901. Main baffle shall be reinforced to tank walls, floor and lid.

Fully Removable Lid
The lid shall be a bolt down fully removable and designed to allow full access to the tank. Lid will be 5/16" or more composite laminate reinforced construction. Lid is bolted in place with stainless steel bolts, with no part of the bolts making contact with the tanks contents. Bolts are located on 4" centers around full lid perimeter and transverse baffle on 8" centers. Lid is sealed with a full perimeter closed cell neoprene gasket. Exterior is red in color.

Fill Tower
The fill tower shall be 9", 10", 12" square or 12 x 15 (or larger to suit design) with hinged, spring loaded access lid with a plastic screen strainer.

Overflow
Depending on design needs, there shall be a 3", 4" or 6" ID overflow pipe installed from the fill tower to the bottom of the tank. The overflow pipe shall be sch 40 with discharge to beneath tank through floor.

Couplings
All threaded couplings shall be CFP's special PVC schedule 80 pipe fittings. Each coupling shall be bonded to the tank shell. All intakes shall have a pressure deflector bonded to the back side to direct pressure away from partitions and reduce agitation.

Air Vent/Overflow
There shall be an air escape venting in the tank to allow maximum fill capacity should the vehicle be parked on unlevel ground.

Sump
A sump will be located to suit the design. The suction connection plumbed in with 4" ID oversized pipe. An anti-swirl baffle that functions like a low level strainer is installed to insure the strong non-cavitating operation of the pump.

Valves (Drop style for full discharge of load)
Dump valves shall be ___ of ___" sized square or round flanged discharges.

Tank to Pump
There shall be ___ of ___" suction connection(s) smooth ___ or NPTF ____

Pump to Tank
There shall be a ___" fill ___ NSTF with deflector per NFPA standards.

Direct Fill
There shall be ___ of ___" fills NSTF with deflector(s) located on the rear bulkhead of the tank.

Foam Cell(s) (Option)
There shall be a foam cell(s) of ___ gallons and ___ gallons. All foam cells shall be equipped with gasketed fill tower, vent, screen and outlet.

Warranty
The tank shall be issued a Custom Fiberglass Products Unlimited Time warranty with $200 per day out of service guarantee and transfer option.